First check if the filter at the washer end of the hot water hose is intact and not broken etc. Unplug the control panels wire connector from the main control board. Maytag 27 in. 3.5 cu. ft. Top Load Washer with Commercial-Grade Mount the main front panel on the cabinet. Using a flat-blade screwdriver if needed, pry the wire harness retaining bracket off the cabinet. Damaged washer hoses Cause #6. If you already know how to fix a Whirlpool washer, your mission is complete. Leaks can happen under the washer if the hoses are bent or broken. Lift the panel off the machine and set it aside. Using your screwdriver, take out the bolt next to the dispenser opening on the control pry the control panel off the cabinet and set it aside. Release the drain pump wire from the retainer. Move the detergent dispenser out of place, then disconnect the dispenser hose from the port at the top of the drum. Using a 7/16 inch socket wrench, take out the bolt holding the agitator to the inner tub. However, this can be caused by three different things: Worn rubber seal The most common cause of leakage on the front of the washing machine is the incorrect closing of the door. (Answered), Maytag Dishwasher Buttons Not Working? Reconnect the two outlet hoses to their appropriate ports on the pump, then slide the spring clamps into place. Step 3. Step 40. Disconnect the grounding wire from the motor assembly. Step 12. Push the drive block back onto the transmission shaft. Remount the main front panel on the cabinet, then use your Torx screwdriver to apply the screws. Please. Repeat this procedure with the other three shocks. Step 9. Step 59. Step 36. More help understanding your washing machine You can email the site owner to let them know you were blocked. Plug the control panel wire connector into the main control board, then secure the wire in the retainers. Fit the door gasket around the front panel. Too much detergent can stop up the dispenser and cause dirt and residue to build up in the detergent drawer, which can cause leaks. Step 5. Set the washer to its lowest water level and power it on. Turn the filter knob, then let any water that may be stuck in the drum drain out. Step 5. Carefully rotate the drive pulley and take the belt off. Loop the drive belt around the motor pulley and transmission pulley (ensure that the belt is turned with the grooved side facing inwards).
